Window ballast tools

Must always have an. Ribbed Balance. Only used on some Peachtree windows. Spiral Balances. Example Carrier. Always has a plastic carrier attached. Don't confuse with Tilt Series. Always has plastic end attached. Not yet on-line. Call us. Always has metal guide attached. Swing the top of the spring toward the window frame as you push down on the spring to increase the tension.

Continue to push down on the spring balance until you can hook the top of the balance beneath the clip or screw in the frame. Install one side of the sash into the top of the window frame. Push the sash against the frame until you can insert the opposite side of the sash in the frame.

Lower the sash until it engages with the bottom of the replacement spring balances. Push the bottom of the take out clips into the window frame or tighten the screws so they are flush with the frame.

Raise and lower the sash two or three times to ensure the window operates properly. Replace the stops in the frame if applicable. Cecilia Harsch has been writing professionally since She writes mainly home improvement, health and travel articles for various online publications. She has several years of experience in the home-improvement industry, focusing on gardening, and a background in group exercise instruction. Harsch received her Certified Nurses Assistant license in She attended Tarrant County College and studied English composition.

By Cecilia Harsch Updated December 17, Double-hung Windows Tilt the upper sash back and snap it into its track in the window. Tilt the lower sash into the window opening and snap it into its track. Hold the window screen frame with the spring clips on the left and the felt strip side or bottom facing you.

Pull the lower sash down to close the window. Using a pencil, dot the position of the stays fixing holes onto the casement frame. Drill pilot holes and screw the stay to the casement frame.

Close the window and ensure it is tight against the frame. Position the pins under the stay so that each line up with holes to both ends of the stay. A window balance is a somewhat hidden window component sitting inside the window frame.

It's only found in double hung or single windows and assists you with the weight of the sash as you open and close your windows. They also hold the top sash of double hung windows closed while they're not in use. Insert or Pocket Replacement Windows Some replacement windows can be installed from the interior or exterior.

Check the manufacturer's documentation to get specific instructions for your windows. Step 2: Sand wood surfaces, if needed. All surfaces and arrises should feel smooth. Step 3: Prime the sash. Step 4: Sand primed surfaces, if needed. Step 5: Bed the pane. Step 6: Set glazing points.